Difference between revisions of "Knowledgebase - Planned Enhancements"
From Protocase Designer Documentation
Line 1: | Line 1: | ||
Planned enhancements are added here when they are identified and approved for development. | Planned enhancements are added here when they are identified and approved for development. | ||
* '''Knock out / Punch out Cutouts''' | * '''Knock out / Punch out Cutouts''' | ||
+ | * '''Tie-Down Fasteners''' | ||
* '''Notches in Bends''' - Adding the ability to Notch a bend when cutouts are placed in a position that the bend is likely to cause them to stretch. | * '''Notches in Bends''' - Adding the ability to Notch a bend when cutouts are placed in a position that the bend is likely to cause them to stretch. | ||
* '''D-Port cutouts''' - We will be updating the placement of D-ports to allow two flat edges. | * '''D-Port cutouts''' - We will be updating the placement of D-ports to allow two flat edges. |
Latest revision as of 13:06, 20 February 2024
Planned enhancements are added here when they are identified and approved for development.
- Knock out / Punch out Cutouts
- Tie-Down Fasteners
- Notches in Bends - Adding the ability to Notch a bend when cutouts are placed in a position that the bend is likely to cause them to stretch.
- D-Port cutouts - We will be updating the placement of D-ports to allow two flat edges.
- 3D Dimension Lines
- Currently the font-size of dimension lines is not consistent and changes depending on what you're dimensioning. This will be improved in a future release to always default to the same value when placing a dimension line.
- The displayed measurement after creating a dimension line currently defaults to the angle value. This will be improved in a future release to default to the delta XYZ values.
Until any one of the following enhancements is added to Designer, you can add a note in your design asking for it:
- Louvres
Until any one of the following enhancements is added to Designer, please call and talk to our technical staff to add it to your design:
- Machining (see [CNC Milling] for details)
- Hybrid enclosures (see [Hybrid Enclosures (Extruded/Milled)] for details)
The following feature has not yet been fully implemented:
- Cutout Library Manager > Create Sub Assembly: When loading an item you have created, its 2D footprint is displayed, and not the 3D View.
See Also: