Knowledgebase - Planned Enhancements

From Protocase Designer Documentation
Revision as of 14:15, 1 March 2018 by Mrodden (talk | contribs) (Notification of implemented top flange on divider)

Jump to: navigation, search

Planned enhancements are added here when they are identified and approved for development.

  • Notches in Bends - Adding the ability to Notch a bend when cutouts are placed in a position that the bend is likely to cause them to stretch.


Until any one of the following enhancements is added to Designer, you can add a note in your design asking for it:

  • Rubber feet on enclosures
  • Louvres
  • Screws or welding to fasten brackets
  • Hinges
  • Drawer slides
  • Flange for U-Shape with Divider: The U Shape enclosure (with Divider) will have a flange added at the top. Until then, to add bends and flanges, add a note to your design requesting Engineering & Design Services to add them for you. For example, if you want a bend/flange on the top side of the divider so that the cover and the divider can be fastened together, open the divider face in the Face Editor, click the face, then add a note in the Properties panel such as, "Add a flange to the top side of the divider so that the cover can mount to the divider."

This has been implemented as of Designer version 4.6.16

Until any one of the following enhancements is added to Designer, please call and talk to our technical staff to add it to your design:



The following feature has not yet been fully implemented:

  • Cutout Library Manager > Create Sub Assembly: When loading an item you have created, its 2D footprint is displayed, and not the 3D View.



See Also: