Knowledgebase - Planned Enhancements

From Protocase Designer Documentation
Revision as of 19:27, 27 July 2021 by Cduffney (talk | contribs)

Jump to: navigation, search

Planned enhancements are added here when they are identified and approved for development.

  • Notches in Bends - Adding the ability to Notch a bend when cutouts are placed in a position that the bend is likely to cause them to stretch.
  • D-Port cutouts - We will be updating the placement of D-ports to allow two flat edges.
  • 3D Dimension Lines
    • Currently the font-size of dimension lines is not consistent and changes depending on what you're dimensioning. This will be improved in a future release to always default to the same value when placing a dimension line.
    • The displayed measurement after creating a dimension line currently defaults to the angle value. This will be improved in a future release to default to the delta XYZ values.



Until any one of the following enhancements is added to Designer, you can add a note in your design asking for it:

  • Louvres
  • Hinges
  • Drawer slides



Until any one of the following enhancements is added to Designer, please call and talk to our technical staff to add it to your design:



The following feature has not yet been fully implemented:

  • Cutout Library Manager > Create Sub Assembly: When loading an item you have created, its 2D footprint is displayed, and not the 3D View.



See Also: